Nany blue seed beads
Pink seed beads
Yellow seed beads
Blue glass seed beads
Light purple pearl beads
Brass earring hoops
Brass jump rings
0.3mm jewelry wire
Gold iron headpins
Gold earring hooks
Long nose plier
Round nose plier
Side cutting plier
Scissors
Step 1: Make the inner beaded layer.
1st, tie the jewelry wire to the earring hoop and slide a bead on, then twine the bead around the hoop as the image shows below.
2nd, continue thread seed beads to the wire and twining the wire until the hoop is fully covered by beads.
1st, string a pink seed bead to the wire, and thread the wire through the bead downside. Thread upward and string a new pink bead.
2nd, repeat the previous process until the second layer is finished.
3rd, go ahead to make a yellow beaded layer and a blue beaded layer.
Thread a pink pearl bead and a navy blue seed bead to each headpin and make a loop at the end. Then attach the pearl bead dangles to the blue beaded layer. Make sure they are fixed tightly.
Connect the earring hooks and earring drops with lobster clasps.